Siemens
Part # FI11467 (old P/N 3172 (same calibration as P/N 3102 but with a 12
ohm coil)
All
tests run with n-Heptane (0.6855g/mL) @ 20oC (+/-1oC),
3.0 Bar (+/-0.01 Bar) (43.5PSI) , 14VDC (+/-0.05VDC), saturated driver
wtih RC cutoff. Gas (0.735g/mL) ratings converted at a 1.035:1 ratio.
Static Flow Rate @ 43.5PSI
(300kPa) w/Gas: 56.9 lb/hr = 7.17g/s = 586cc/min (+/-4%)
Dynamic Flow Rate 2.5ms
PW @ 100Hz: 13.6 mg/pulse (+/-4%)
Coil Resistance: 12 Ohms
(This
high-impedance injector will work with all factory ECM/PCM injector drivers)
Spray Pattern: Pencil
Connector: Minitimer (Bosch
EV1)
>
Click here for dimensions <
Factory fitted with Viton
upper and lower o-rings.
Grease supplied to lubricate
o-rings prior to installation.
Note: Some new production
has silver colored bodies vs. black.
Dynamically
flowed and grouped to within 1% tolerance using Racetronix custom
injector flow bench
Note:
Some injector flow rates have been converted from n-Heptane test solvent
to 40CFR86.113, the U.S. EPA emission test gasoline. However, n-Heptane
is not gasoline and flows in most common injector designs at about a 3
to 4% lower rate than 40CFR86.113, the U.S. EPA emission test gasoline. |
