
|
Racetronix Disc Injector 37 lb / hr $34.50 each LIMITED QUANTITIES AVAILABLE |
click on image to zoom |
|
||||||
| Part
Number: D3165BA (Lucas old 5203002, Lucas New 621037)
All tests run with n-Heptane @ 20oC (+/-1oC), 3.0 Bar (+/-0.01 Bar), 14VDC (+/-0.05VDC), saturated driver wtih RC cutoff Static Flow Rate: 37.27 lb/hr (+/-4%) Dynamic Flow @ 2.5ms PW @ 100Hz: 8.42 mg/pulse (+/-6%) Coil Resistance: 15.9 Ohms (+/-0.35 Ohms) (This high-impedance injector will work with all factory ECM/PCM injector drivers) Spray Pattern: Split 20o (+/-4o) >65% of delivery within 10 degrees Physical Dimensions: EV1 Body Type Connector: Minitimer (Bosch EV1) Factory fitted with Viton upper and lower o-rings. Grease supplied to lubricate o-rings prior to installation. Click here for Injector dimensions ADDITIONAL INFORMATION: Top feed disc injectors use a small disc with six holes around its circumference. The disc rests on a short chimney that surrounds a metering hole. As the disc is raised off the chimney by magnetic force, fuel flows through the holes in the disc, over the walls of the chimney, and out the metering hole to form a full, finely atomized cone. Performance
advantages over pintle injectors (i.e. Ford / Bosch & Accel types)
as listed by Delphi:
|
||||||||