M.S.R.P.  $41.50ea

Static Flow Rate: 31.6 lb/hr = 239.4 g/min = 349 cc/min (+/-4%)
Dynamic Flow @ 2.5ms PW @ 100Hz: 6.68 mg/pulse (+/-6%) 
Coil Resistance:  16.2 Ohms (+/-0.35 Ohms) (This high-impedance injector will work with all factory ECM/PCM injector drivers)
Spray Pattern: 4 degree pencil
Physical Dimensions: EV1 Body Type
Connector: Minitimer (Bosch EV1)
Factory fitted with Viton upper and lower o-rings. 
Grease supplied to lubricate o-rings prior to installation.
Click here for Injector dimensions

Note: Injector flow rates are based on testing with n-Heptane test solvent (0.6855 g/ml). U.S. EPA emission test gasoline 40CFR86.113 (0.735g/ml) flows in most common injector designs at about a 3 to 4% higher rate than n-Heptane. A ratio of 1.035:1 can be used when converting the flow specifications above.

TYPICAL APPLICATIONS:

• High-performance
• replacement for Ford/Bosch M-9593-B302(F), M-9593-B304(F), 0280150218, 
• GM 1987-1986 V6, 3.8, 231,7, Turbo
• Replacement for GM Part Number 25519365
• 1985 V6, 3.8, 231, 9, Turbo
• 1985 V6, 3.8, 231, 9, Turbo

ADDITIONAL INFORMATION: 

Top feed disc injectors use a small disc with six holes around its circumference. The disc rests on a short chimney that surrounds a metering hole. As the disc is raised off the chimney by magnetic force, fuel flows through the holes in the disc, over the walls of the chimney, and out the metering hole to form a full, finely atomized cone.

Performance advantages over pintle injectors (i.e. Ford / Bosch & Accel types) as listed by Delphi:
• The flat mating surface ensures that no excess fuel is present to evaporate and therefore, no deposits or clogging can occur.
• Compatible with alternative fuels (i.e. E85, Methanol) 
• Longer service life
• High-speed disc action allows wider dynamic flow range for improved idling
• Quieter operation
• Revolutionary disc design resists build up deposits which can affect fuel flow.
• No Fuel leakage for quicker starts